Some items are
SPECIAL ORDER Please call
and we will Drop Ship if available from manufacture..
(916) 218-2153
This is the Radio Controlled, Glow Powered 1/8 scale
Mugen MRX5 On-Road Racing Car Kit.
FEATURES: Chassis: Aluminum 0.20" (5mm) polished natural finish, with new
chassis flex system and stiffener
Drive: Four wheel belt
Transmission: Two-speed
Shocks: Oil-filled with 600W silicone shock oil
Camber Tie Rods: Adjustable, Camber describes the angle at which the
tires sit vertically
Clutch: Three-shoe composite
Suspension: Front anti-roll bar, ball bearing equipped rear sway bar
Steering Tie Rods: Adjustable, Caster/Toe-in is the angle at which
the tires point inward as viewed from above
Steering: Fast change Ackerman
Ackerman describes the effect of the inside
front wheel turning faster than the outside front wheel during
turns
INCLUDES: MRX5 On-Road Racing Car Kit with Shock Oil, Decals and Instruction
Manual
REQUIRES: Radio: 2-channel with high-speed steering servo
Engine: .21 cu in rear exhaust
Exhaust: Tuned pipe
Receiver Battery: 6V flat
Fuel: car blend with 20% lubricant
Starter box, glow starter and track equipment
SPECS: Length: 17.4" (441.63mm)
Width: 10.3" (262mm)
Wheelbase: 11.8" (299mm)
Tread: Front, 8.5" (216mm)
Rear, 7.9" (202mm) outer edges of tires side to side
Front Caster Angle: 8.5 - 15.5mm
Gear Ratio: 1st 7.35:1,
2nd 5.52:1
Weight: 5.51lbs (2500g)
COMMENTS: For replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
2 12x18mm Front One Way 1 DTXC1597
4 12x18mm Front Upright 2 DTXC1597
2 5x8mm Servo Saver 1 DTXC1523
2 10x15mm Middle Shaft 1 DTXC1595
2 12x18mm Rear Pulley 1 DTXC1597
2 5x8mm Rear Anti Roll Bar 1 DTXC1523
4 12x18mm Rear Uprights 2 DTXC1597
2 size not given, 2-Speed
1 size not given, Belt Tensioner